FoundryLogic LLC Copyright © 2012.  All Rights Reserved.        Email for Info Retail Mobile Suite™              Mobile Hardware Configuration Notes • Configure Scanner Check the scanner configuration by going to Start > Power Tools > EZConfig Utilities > ScanWedge. When the ScanWedge applet comes up, go to Scanwedge > Settings as shown: Check the following settings: o Ensure that PrefixKeys is enabled and its value is 12. o Ensure that SuffixKeys is enabled and its value is 13. o Ensure that SendMode is enabled and its value is Virtual Keys. Next, click VKMapping and add insert a new key for 12, as shown, if not already present: • Launch Scanner Lanch the ScanWedge scanner applet by going to Start > Power Tools > ScanWedge. Note, you will need to restart the ScanWedge application anytime you make a change to the ScanWedge settings. • Symbology Specific Settings – Depending on your labels, you may also need to check the settings for individual symbologies. From the ScanWedge setings, click Sybologies. • Retail Mobile Suite Settings – On your device, go to Device Configuration > Wedge. Click Reset. Scan a barcode. This step trains Retail Mobile Suite as to which buttons on the device initiate scans. Honeywell 6100, 7600, 7850, & 9700 Installing and configuring Honeywell 6100, 7600, 7850, & 9700 series mobile devices is quick and easy Installation Notes • .NET Compact Framework – Windows Mobile 6 versions have .NET CF 2.0 already installed, but the installer will try to install it anyway. You may simply cancel the installation of .NET CF 2.0 • SqlCE – After SqlCE is installed, you will probably be asked to reboot your device. Please reboot and wait until the device reconnects before continuing.